Universal Laser Systems VLS3.50 Guide d'installation télécharger pdf (Page 11)

Universal Laser Systems VersaLASER VLS2.30 and VLS3.50 Installation and Setup Guide

Finalizing the Connections

Make the following connections in the order described, otherwise static electricity can potentially damage the

computer and/or the laser systems electronics.

Connect the 3-inch (76.5 mm)  exible rubber exhaust system to the rear of the laser system if you have not1.

already done so.

Connect the laser system’s power cord and your computer’s power cord to a grounded electrical outlet. 2.

Note:

A properly installed 9-volt battery is necessary to operate the laser system. The laser system will not

function without a charged battery installed. Keep a spare 9-volt battery on hand at all times.

Do not power on the laser system at this time.3.

Install the provided 9-volt Thermal Sensor battery into the back of the VLS laser system.4.

Gently push up on the Thermal Sensor battery holder drawer as indicated.a.

CAUTION: Make sure that you attach the adapter correctly to the power cord and that your

power source is properly grounded (earthed).

Note: International users may need to connect an adapter to the power cord to be able to plug it into their

power source.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17

Pas de commentaire

Universal Laser Systems VLS3.50 Guide d'installation Page 11